PCB FABRICATION & ELECTRONICS ASSEMBLY
Engineering resources/Project support
SWIMBI RESOURCES

Category: Flex and HDI

Find a practical answer for your next design review: board construction, materials, manufacturing files, assembly and verification. Search by the problem you are solving, then use the related field guides to prepare a project brief.

October 4, 2026

Qualifying Copper Pretreatment for Laser Direct Drilling

Treat copper surface preparation and laser parameters as a matched process when evaluating via formation.

Read article
October 4, 2026

Checking Blind-Microvia Wetting Before Adjusting Copper Plating

Use the defect location and process sequence to distinguish trapped gas or poor wetting from plating-rate problems.

Read article
October 4, 2026

Inspecting Flex Surfaces After Removing Rigid Window Covers

Examine the newly exposed flex and transition after sacrificial rigid material is removed.

Read article
October 4, 2026

Planning the Removal of Temporary Flex Handling Tabs

Control sacrificial flex supports so separation does not leave a notch or damage an installed tail.

Read article
October 4, 2026

Supporting Exposed Copper in Dual-Access Flex Windows

Review back-bared access windows as unsupported conductor regions rather than ordinary plated vias.

Read article
October 4, 2026

Checking Rolling-Loop Migration Across the Full Flex Stroke

Track where curvature travels during motion so the loop cannot reach a clamp, shield edge or housing obstruction.

Read article
October 4, 2026

Containing Solder Spread Within a Supported Flex Terminal

Inspect the soldered extent of a flex termination against the support and bend boundaries.

Read article
October 4, 2026

Designing Access to Remove a Flex Mounting-Adhesive Liner

Make the release liner and removal sequence part of the flex drawing so installation does not damage the circuit.

Read article
October 4, 2026

Aligning FPC Retention Tabs with the Connector and Stiffener

Inspect lateral locking features and local support alongside the familiar contact pitch and tail thickness.

Read article
October 4, 2026

Verifying Ground Contact Through Flex Shield-Film Windows

Check the electrical connection between a laminated shield film and its intended grounding lands.

Read article