PCB FABRICATION & ELECTRONICS ASSEMBLY
Engineering resources/Project support
SWIMBI RESOURCES

Category: Design fundamentals

Find a practical answer for your next design review: board construction, materials, manufacturing files, assembly and verification. Search by the problem you are solving, then use the related field guides to prepare a project brief.

October 14, 2026

Choose Sensor Update Rate from the Event You Need to Observe

Select sensor sampling, filtering, and reporting rates from the event duration and decision requirement rather than an arbitrary refresh interval.

Read article
October 9, 2026

Turn a Product Accuracy Claim into an End-to-End Error Budget

Allocate a product accuracy requirement across the sensor, analog path, conversion, environment, and calibration instead of using ADC resolution as the specification.

Read article
October 4, 2026

Reading RTC Time Registers Without Mixing Two Seconds

Use the RTC’s snapshot mechanism to keep seconds, minutes, and date fields from different instants out of one timestamp.

Read article
October 4, 2026

Testing I2C Arbitration Loss with Multiple Controllers

Verify that the losing controller releases the bus and retries without corrupting the winning transaction.

Read article
October 4, 2026

Budgeting EEPROM Endurance at the Physical Write Unit

Map frequent updates and wear-level metadata to the EEPROM’s internal write grouping before estimating lifetime write demand.

Read article
October 4, 2026

Defining the Event That a Switch Debounce Circuit Must Produce

Specify press, release and repeated-operation behavior before selecting a debounce interval or RC network.

Read article
October 4, 2026

Review Tactile Switch Travel with the Enclosure Button and PCB Support

Control button travel and load transfer so that enclosure tolerances do not overload a board-mounted tactile switch.

Read article
October 4, 2026

Assign the Exposed Thermal Pad to Its Specified Electrical Net

Verify the electrical role of an exposed pad before connecting its copper and thermal vias to a convenient plane.

Read article
October 4, 2026

Map FFC Contact Faces and Pin Numbering Between Both Connectors

Verify the exposed conductor side and end-to-end pin map before approving a flat cable and connector pair.

Read article
October 4, 2026

Review the Full Fastener Envelope Around a PCB Mounting Hole

Include screw heads, washers, spacers and tool access when checking electrical and mechanical clearance around mounting points.

Read article